RCBS ChargeMaster Lite Scale / Dispenser System Repair

Repairing your RCBS Scale / Dispenser system is our most cost saving alternative compared to purchasing a new unit of the same caliber. Typically the equipment only needs an inexpensive repair to bring it into specifications and have it perform like new.

What makes us different from other electronics repair shops? We offer COMPONENT LEVEL ELECTRONICS REPAIR. Other electronics repair shops will deem equipment unrepairable if the problem is not an easy fix. We don't let that stop us! If there is any way to save your equipment, Lone Mountain Communications will not only save it, but make it perform like new. In addition, we offer attractive warranties on our repairs. We also use ESD static protection at all phases of the repair.

We have repaired the RCBS ChargeMaster Lite / Dispenser combo system from customers all over the world. These clients are referred to us directly by the RCBS manufacturer. The factory depot does not repair this unit any longer so using Lone Mountain Communications as your service facility only makes sense. LMC is the only company that repairs this unit currently. So don't throw out that old equipment or buy new without consulting with us first. Your equipment may just need an inexpensive repair to make it work like new!

Please contact us so we can discuss your needs in this critical area.

• DAMAGED L.C.D. SCREEN
• EXTENSIVE POWDER CORROSION TO OUTER HOUSING ASSEMBLIES
• THE GREEN "GO"  and/or  RED "POWER" SWITCHES DO NOT FUNCTION
• FEEDSHAFT TUBE DISLODGED FROM HOPPER
• FEEDSHAFT TUBE BENT / WARPED
• NO DISPENSING OPERATION
• TAKES TOO LONG TO COMPLETE A DESIRED CHARGE
• WEIGHT MEASUREMENTS ARE INACCURATE
• SYSYTEM DOES NOT POWER UPAT ALL
• TRICKLE MODE INOPERABLE
• CANNOT CALLIBRATE SCALE
• WHEN IDLE - WEIGHT MEASURED WILL FLUCTUATE  +/-   AND WILL CONTINUE TO INCREASE / DECREASE

WARNING -

The RCBS CHARGEMASTER LITE digital scale is for use with smokeless powders only.  Do not use with black powder (used in muzzle loading firearms). If black powder should come in contact with an electrical spark, an explosion may occur, resulting in serious injury or death.

Check calibration prior to each use of the scale and re-check frequently during use with the calibration weights provided. A spot check can easily be made during operation with an RCBS Scale Check Weight Set. If accuracy is found to be out of tolerance, the scale must be recalibrated as explained in the CALIBRATION section of the instruction manual. A scale with improper calibration will cause an incorrect charge weight which may exceed the maximum recommended load.  

CALIBRATION PRECAUTIONS:

Digital scales are very reliable devices. However, here are some events which may result in an inaccurate reading:  * Change in temperature. If the temperature changes more than a few degrees, you must recalibrate the scale.  Allow scale tostabilizefor20-30minutespriortouse.* Changes in scale location or an un-level working surface.* Un-centered weights on the platen. * Jarring of the scale during operation.* Use only the two calibration weights supplied for accuracy. *Weight accuracy is crucial. Keep weights clean and carefully stored. If dropped or damaged, have weights inspected against known standards. Contact RCBS Customer Service. * Static electricity can cause the scale to "jump around". If static build-up is evident, wipe scale with an anti-static sheet, or use anti-static spray. Spray on clean soft cloth first. Do not allow spray to get into mechanism. * If powder should get inside the unit, stop operation immediately and do not use scale until it has been serviced. Contact RCBS Customer Service.* Do not press on the platform with your hand. You can damage the load cell.

 

PO Box 194, Pearce AZ 85625 : Tel: (520)826-1200
Copyright © 2023